Domino Sim2 Manuel d'installation télécharger pdf (Page 12)

POWER OFF

INITIALIZATION

STATE NOTES

INDICATORS

GREEN RED

STANDBY

OPERATING

COOLING LAMP

WARNING

ERROR

The Power is turned off

Power button has been pressed and the software is initialized (15 s)

Projector is in standby mode

Projector is on

Projector is powering down; the fans are running to cool the lamp (1 min)

Problems to display one or more source

Internal circuit failure

OFF

FLASHINGFLASHING

FLASHING

OFF

FLASHING

6 CONNECTIONS

To obtain the best performance from your projector, we

recommend the use of good quality “video cables” to the various

signal sources (75 ohm Impedance).

Poor quality cables will cause inferior picture performance.

For optimum connectivity we recommend you follow these

simple steps:

- With exception of coaxial RCA/Phono type connectors,

always double-check that the plug is inserted the correct

way round to avoid damaging the plugs or the sockets on

the projector

(Fig. 15)

C-SYNC

Fig. 15

- Remove cables by the plug and do not pull on the cable

itself.

- Avoid tangled cables.

- Position the cables carefully to avoid a trip hazard - especially

in low light areas.

SWITCHING OFF AND RETURNING TO STAND-BY

By remote control: press

By keyboard: press key

When switching off, the projector goes in to stand-by

memorising the input selection at the time of switch-off.

The fans will continue to work until the lamp has cooled down

(red and green LEDs flashing) and will stop automatically after

this period.

LED INDICATORS

The LED indicators, located in the top-rear of the projector,

provide information about the state of the projector (see table

below).

Downloaded From projector-manual.com Sim2 Manuals

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Domino Sim2 Manuel d'installation Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Domino Sim2